GREPSPUD 2 Sets Galvanized Trailer Hub Kits 5 on 4.5'' for 3500 lbs 1-1/16'' to 1-3/8'' #84 Tapered Axle, Prelubricated L44649 L68149 Bearings 5x4.5 Trailer Idler Hub 5 Lug Bolt Trailer Wheel Hub Kit

Additional Details from the Manufacturer

This item information is coming from the manufacturer. Some of the details may vary from the Nellis Auction listing. Please check the Quality Rating and Notes for information specific to this listing

More features

• 【APPLY TO】- Fits 5 holes wheel 3500lbs Trailer 1-1/16'' to 1-3/8'' Tapered Axles EZ-Lube #84 Spindle, not for straight spindle. Fits L44649 outer bearing and L68149 inner bearing.
• 【SIZE】- Please check the size picture, 5 bolts pattern is from the OUTERMOST point of a hole to the CENTER of another hole. Please measure the size before purchase to avoid delayed repair and replacement due to wrong size.
• 【PRE LUBRICATION】- The bearings and grease seals are pre-assembled and lubricated with grease, sealed with plastic caps to prevent leakage. This kit includes all the necessary parts for installation, you can directly install them on the trailer axle. You don't have to go anywhere else to buy parts.
• 【ANTI-RUST & STURDY】- The wheel hub surface is hot-dip galvanized, providing a thicker coating and great corrosion resistance compared to black spray painting. Dust cap surface zinc-plated, anti-corrosion & anti-rust. The bearings have high precision, low friction and low noise. These hardware are made of high quality steel and rubber, heavy duty, long-term service for your trailer.
• 【STURDY PACKAGING】- The trailer hubs are wrapped with bubble bags. The bearings and grease seals have been pre assembled on the hubs. Other installation hardware are wrapped in white bubble bags. All parts are neatly placed in a sturdy cardboard box. The products are protected as much as possible during transportation to prevent deformation and wear.
• 【NOTE】- In order to install firmly, the axle dust cap is slightly larger by design. You need to knock it into place using a wood block and hammer or rubber mallet, to prevent denting the cap while installing.