Carter WO Carburetor Brand NEW For (A1223) willys MB CJ2a Ford GPW Army jeep 539 2.2L 2197CC 134Cu. In. l4 GAS L-HEAD Naturally Aspirated.Carburetors may not fit some years CJ2A 134cid engine

Additional Details from the Manufacturer

This item information is coming from the manufacturer. Some of the details may vary from the Nellis Auction listing. Please check the Quality Rating and Notes for information specific to this listing

More features

• Please note that the carburetor has been tested by the engine and is 100% qualified. When installing the carburetor, it needs the help of an experienced mechanic. It is not suitable for novices to install. You can use carburetor cleaner to clean the position of the fuel inlet before installation.
• NEW CARTER WO CARBURETOR FOR WILLYS MB, CJ2A, FORD GPW NEW PRODUCTION.All linkages are replated including a reparkerized cast base. All carbs are sold on an exchange basis and for the same type model.
• The carburetor is of the conventional downdraft, plain-tube type, with a throttle operated accelerator pump and economizer device.The diameter of the carburetor bolt hole is 10mm, the distance between the two bolts is 60mm, and the diameter of the throttle hole is 30mm.
• The idle adjustment screw indicatedabove is the service adjustment provided on the carburetor. To obtain the approximate correct setting, turn the adjustment screw to the right and all the way in, but do not jam the screw against the seat, then, back out adjustment screw between one and two turns. To make the final adjustment, warm up the engine, and adjust the screw until the engine runs smoothly. Set the throttle stop screw so the engine will idle at 600 revolutions per minute
• Inspect condition of gaskets between carburetor and manifold, and install new gaskets, if required. Install carburetor retracting spring clip, and carburetor flange nuts. Tighten nuts evenly, Connect throttle control rod, and throttle and choke wires. Install carburetor air horn, and tighten clamp screws. Adjust carburetor